So if I enter this code
G0 X0 Y0 Z0
M11P1 G1 X10 M10P1
G0 Y1 X0
M11P1 G1 X10 M10P1
M30
And should get two parallel lines 1 inch apart, 10 inches long with the laser coming on and off at the beginning and end of each line with M commands
I didn’t, so I think I have the wrong jumper settings on the C 62 board.
I posted this jumper question on Arturo‘s forum (Cnc4pc).
If anyone is using this board, C 62 I would appreciate comments.
Thanks,
Chuck