Hello Guest it is July 23, 2019, 11:09:40 PM

Author Topic: techno isel refit  (Read 2787 times)

0 Members and 1 Guest are viewing this topic.

techno isel refit
« on: June 13, 2007, 03:07:19 PM »
Hi I have a techno servo router with a dos based controle.
The machine it self an the elctronics work fine.
The controler also works but its a pain.
Does anybody hear have any experience converting one of these to run with mach3 or an older version.
I was hoping to be able to somehow interface with the aktual box rather then having to build a new one with gecko drives ore something like that.

at the moment I just want to no if anybody here has already done so or at least thought about it.

Thanks

KAI
Re: techno isel refit
« Reply #1 on: June 14, 2007, 09:33:55 PM »
You will need to put up pictures and more info about the servo drives the machine has.
Re: techno isel refit
« Reply #2 on: July 16, 2007, 10:05:16 PM »
I converted my Techno control to work of Mach3.  When I purchased my machine it did not come with any Techno control software or pc boards.  I established which wires controlled the step and direction for the motors and setup Mach3 to use the existing Techno controls and drives.  Recently I upgraded my system to Servo motors and Gecko 320  drives.  I will post some pictures in the future of my setup.