Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: kaimaui on June 13, 2007, 03:07:19 PM
-
Hi I have a techno servo router with a dos based controle.
The machine it self an the elctronics work fine.
The controler also works but its a pain.
Does anybody hear have any experience converting one of these to run with mach3 or an older version.
I was hoping to be able to somehow interface with the aktual box rather then having to build a new one with gecko drives ore something like that.
at the moment I just want to no if anybody here has already done so or at least thought about it.
Thanks
KAI
-
You will need to put up pictures and more info about the servo drives the machine has.
-
I converted my Techno control to work of Mach3. When I purchased my machine it did not come with any Techno control software or pc boards. I established which wires controlled the step and direction for the motors and setup Mach3 to use the existing Techno controls and drives. Recently I upgraded my system to Servo motors and Gecko 320 drives. I will post some pictures in the future of my setup.