Welcome, Guest. Please login or register.
Did you miss your activation email?
May 27, 2012, 11:55:11 PM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Mach Discussion
| |-+  General Mach Discussion
| | |-+  Long pierce delay
Pages: 1   Go Down
« previous next »
Print
Author Topic: Long pierce delay  (Read 202 times)
0 Members and 2 Guests are viewing this topic.
streetbikedepot
Active Member

Offline Offline

Posts: 4


View Profile
« on: June 30, 2011, 09:25:38 AM »
I'm having a problem with a delay in my pierce even when the pierce delay is set to 0.0 in Sheetcam.  I have a THC301d and it gets an arc ok signal immediately after the firing of the torch and there is still @ 2 sec of delay while no G04 Px.x shows in the code.  Anyone have any ideas?   
Logged
Hood
Active Member

Offline Offline

Posts: 17,366


Carnoustie, Scotland


View Profile
« Reply #1 on: June 30, 2011, 10:10:35 AM »
Not sure about how plasma works but could it have anything to do with spindle delay settings on General Config page/
Hood
Logged
streetbikedepot
Active Member

Offline Offline

Posts: 4


View Profile
« Reply #2 on: June 30, 2011, 10:51:19 AM »
BINGO!  Thanks for the tip, that fixed it.
Logged
manmeran
Active Member

Offline Offline

Posts: 241


View Profile
« Reply #3 on: June 30, 2011, 10:54:06 AM »
you check this parameter if you set pierce delay to 0 in sheetcam :
Config / Port and pin /spindle setup /General parameters

Amir
Logged
**Even a clock that does not work is right twice a day**
Widgedy
Active Member

Offline Offline

Posts: 11


View Profile
« Reply #4 on: July 03, 2011, 06:33:33 AM »
Cool,
always wondered about that but it hadn't bothered me enough to ask.

Thanks.
Logged
Pages: 1   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!