Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: streetbikedepot on June 30, 2011, 10:25:38 AM
-
I'm having a problem with a delay in my pierce even when the pierce delay is set to 0.0 in Sheetcam. I have a THC301d and it gets an arc ok signal immediately after the firing of the torch and there is still @ 2 sec of delay while no G04 Px.x shows in the code. Anyone have any ideas?
-
Not sure about how plasma works but could it have anything to do with spindle delay settings on General Config page/
Hood
-
BINGO! Thanks for the tip, that fixed it.
-
you check this parameter if you set pierce delay to 0 in sheetcam :
Config / Port and pin /spindle setup /General parameters
Amir
-
Cool,
always wondered about that but it hadn't bothered me enough to ask.
Thanks.