Wizard Error

[slinghit]

I incorrectly entered a bad input into the Spline and Gear Wizard and saved the value.   Now I can't reset the error.  I keep on getting "Error Rapid Plane <=0******. "E Stop button Pressed"   I have since then entered a value larger than zero but the error will not go away.   Can you help?

In addition, I have disabled the E-Stop in the Pins and Ports but it keeps on enabling itself.  I hit apply after making change.    This is a very small machine and the E-Stop is not really needed for the stepper motors. 

Thanks for any input.

Jay

[Overloaded]

Jay, the estop is permanently enabled as a safety feature, just change the active state and it will then work.
Will look at the wizard later, or someone else will chime in.

[Overloaded]

Dont forget to hit enter after changing a DRO, then click Post code to clear the error. If your new value is valid of course.

[stirling]

As above - It seems it's just the error ticker isn't correctly reset - just ignore it. Just enter a correct value and post the gcode.

Ian

[slinghit]

I hope I am not asking too dumb of questions.

I assume that changing the active state for the E-Stop is disenabling in Input signals?

I thought I had entered the correct value and posted code but the error still will not go away.  I will try again when I get home tonight.

I really appreciate your input.

Thanks Jay

[Overloaded]

No, leave it enabled, just change the Active State under the active low column.

[slinghit]

Thanks, Overloaded!!