Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: slinghit on January 28, 2011, 11:59:38 AM
-
I incorrectly entered a bad input into the Spline and Gear Wizard and saved the value. Now I can't reset the error. I keep on getting "Error Rapid Plane <=0******. "E Stop button Pressed" I have since then entered a value larger than zero but the error will not go away. Can you help?
In addition, I have disabled the E-Stop in the Pins and Ports but it keeps on enabling itself. I hit apply after making change. This is a very small machine and the E-Stop is not really needed for the stepper motors.
Thanks for any input.
Jay
-
Jay, the estop is permanently enabled as a safety feature, just change the active state and it will then work.
Will look at the wizard later, or someone else will chime in.
-
Dont forget to hit enter after changing a DRO, then click Post code to clear the error. If your new value is valid of course.
-
As above - It seems it's just the error ticker isn't correctly reset - just ignore it. Just enter a correct value and post the gcode.
Ian
-
I hope I am not asking too dumb of questions.
I assume that changing the active state for the E-Stop is disenabling in Input signals?
I thought I had entered the correct value and posted code but the error still will not go away. I will try again when I get home tonight.
I really appreciate your input.
Thanks Jay
-
No, leave it enabled, just change the Active State under the active low column.
-
Thanks, Overloaded!!