Hello Guest it is July 15, 2024, 08:59:17 PM

Author Topic: Going with Machmotion  (Read 7067 times)

0 Members and 1 Guest are viewing this topic.

Going with Machmotion
« on: July 13, 2009, 09:45:14 PM »
I decided to buy from Machmotion since I need support and also Vital Systems recommends them, Machmotion, since they are experienced with the controller.


It's the  dspMC/IP all decked out.

I should have the new controller in a few days.
Re: Going with Machmotion
« Reply #1 on: August 10, 2009, 07:38:20 PM »
All up and running!!! Now I have to figure out this tunning deal in Axisworks. Can somebody do a youtube video of how toune in Axisworks?


Re: Going with Machmotion
« Reply #2 on: August 11, 2009, 05:52:09 AM »
Hi Robert,
You sure got it up and running in short order.
The directions in the manual should get you going in axis works.
I used axis works when setting up the mill but don't have any video.
I will be using it again when setting up my lathe in the upcoming weeks/months as I already have all of the electronics installed in a box, I just need the time to get the servos installed. I would be willing to do a video then.

Let me know if I can be of more help and I could always help over the phone if needed.


P.S. Doesn't Machmotion have a video or other support feature.
We never have the time or money to do it right the first time, but we somehow manage to do it twice and then spend the money to get it right.
Re: Going with Machmotion
« Reply #3 on: August 11, 2009, 11:52:21 PM »

That big ol Shinx is is working real good but I don't think the motors are tuned.

I would like to see any AxisWorks video ASAP.  Andy at Machmotion told me he was going to do a video of AxisWorks.