Hello Chip,

   Here are the files you asked for, (I hope)

..............................Edmund............................

Hi, Edmund

The Problem is in your DWG file, there were 2 extra lines on top of the left side line from your 0,0 pos. up about .75 inch and 1 inch. I removed them all is fine now.

Hope this Helps, Chip

Chip,

Here are the 2 files you asked for..

.........................Edmund.....................

Chip, can you explain how to delete extra lines in a autocad DXF? dwg that are not visible until I load into LC, I have grey dotted lines all over the place and at least 10 unwanted lines on a rectangle, even when I click on the blue line of the rectangle the blue line does not change to red completely the unwanted lines are interfering

..................Edmund....................

Hi, Edmund

I loaded the file back into a Cad program and deleted dup. lines there, I think LazyCam's Remove Redundant Button  is for this but is not

implemented at this time.

Hope this Helps,Chip

I get these errors too, in V2.64 especially when I :
- use the right mouse button and get a funny little pop-up tool that has to do with tool chain selection
- Try to use tool direction arrows

There is a new version Of Lacm that will take out redundant lines on it's own.... Try it and see if it works for you...
2.65 should help

How do I that?,  what is the procedure?, when I go into the drawing in autocad and turn off the holes and slot leaving just the outside rectangle there are lines not showing ie its not a complete rectangle, the drawing has 4 layers, but not sure how to delete the lines, the drawing has lines not joined and yet when I load the drawing into LazyCam it shows a complete rectangle, but there are about 8 little stubby lines all connected by grey dotted lines with extra half curves,
What a mess why cant things work for me, its very ex hastberating

...............Edmund...............

Hi, Brian

I have looked at fresh download of Mach3. FTP\LazyCam, and LazyCam download, Can't find ver. 2.65 ?

Can you point me to it.

Thank's, Chip

Hi, Edmund

In your cad program you should be able to Hi lite the line segment that has Dup. items, Delete them, then re-draw the line back in.

Turn on each layer one at a time you may have line segments on the wrong layer, if so delete them then go back to your rectangle layer delete the problem layer then re-draw it.

Post your DXF File

Hope this Helps, Chip