Folks,
First of all... thanks to the help of Ray, Hood and countless others I have managed to get everything up and running... Thank You!
I'll post some pictures shortly....
Everything was working great until I lost power last night half way through the machining process... barley noticed as it wasn't enough to slow the router down, but the PC had to reboot.
Of course, afterwards I had to re-load Mach and the G-Code....
Here's my question ( I think I know the answer already) Is there a way to continue the machining process where it left off? I have not moved the router however when I loaded the G-code back it zeroed everything at the point that the router stopped. Keep in mind that I do not know what line of G-code the machining stopped at, and of course, I am starting at line 1 again.
If not, and I have to start over, is there a good way to insure correct registration ? or do I scrap the piece?
Thanks in advance,
Pete