Hello Guest it is May 23, 2019, 09:29:39 PM

Author Topic: Program runs slow ???  (Read 1936 times)

0 Members and 1 Guest are viewing this topic.

Program runs slow ???
« on: November 01, 2008, 01:19:44 PM »
Helllo I am new here and have just set up a PC to get used to Mach3 before connecting to a machine. I have loaded a program and in simulation mode it flys through it and gives me an estimated cycle of just over a minute. However if I run the program it takes for ever because the rapid and programed feeds are not running at the correct rates. Any clues as to what I am doing wrong?? -  Neil.

Offline Hood

*
  •  25,815 25,815
  • Carnoustie, Scotland
    • View Profile
Re: Program runs slow ???
« Reply #1 on: November 01, 2008, 01:29:24 PM »
Answered in your other thread.
Hood