Hi,
This post is pretty much to keep from being removed from the list. This board is made from Corian (sp?) counter top material. The insert is brass and the pins were made from aluminum knitting needles. It was easier to just put them in a collett and turn the ends rather than turning them from stock. It was made on a Syil SX 3 machine. Although I have had the machine over two years, I have never generated code by hand, I have always used some program to do it for me. I realize that this is very basic for a programmer but for me it was a learining experience and I had fun doing it.
OM

Good Job OM,
    There was another member that had another board posted here in the past.

Brett

Very nice indeed OM.
Here is a link to the one Brett mentioned. (pretty sure)
http://www.machsupport.com/forum/index.php/topic,5306.0.html
Welcome to the club,
RC

Yup, that is the one RC, Thanks.

Brett