Hello Guest it is February 04, 2026, 05:37:40 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Rhinocam post  (Read 14938 times)

0 Members and 1 Guest are viewing this topic.

cdomino

*
Rhinocam post
« on: June 19, 2006, 11:24:22 AM »
If anyone out there is running Mach3 with Rhinocam generated gcode files, would you please recommend a post processor or two that I can check out.

Thanks,
Chris
Logged

Offline Graham Waterworth

*
  • *
  • 2,784 2,784
  • Yorkshire Dales, England
Re: Rhinocam post
« Reply #1 on: June 19, 2006, 11:51:18 AM »
I use a Fanuc 6M post on AlphaCAM.  It works ok for me.

Graham.
Logged
Without engineers the world stops

Offline faby

*
  • 74 74
Re: Rhinocam post
« Reply #2 on: July 29, 2006, 04:59:05 PM »
I use visualmill 5, the engine of Rhinocam, and include a mach2 post option.

Fabiano
Logged
Pages: 1   Go Up
« previous next »