I always hit the enter as well as the SAVE SETTINGS button. Had trouble early on with settings not "Taking".
RC
YES hitting "Enter" is the trick!!!
Now I have another question now that the "Motor Tuning, Steps Per" is working.
I wrote GCode to draw a 1" square. Results below.
Why is the 32,000 run way off size and a rectangle. I was expecting it to be 2" Any ideas. I know this is off topic, and I know how to draw a 1" square now, but it doesn't make sense.
At 32,000 it draws a square that is 1.026" X 1.104 Not square
At 16,000 it draws a square that is 0.986"
At 8,000 it draws a square that is 0.489"
At 4,000 it draws a square that is 0.224"
THanks