Hello Guest it is September 20, 2020, 10:45:38 AM

Author Topic: Newbie Help!  (Read 9307 times)

0 Members and 1 Guest are viewing this topic.

Re: Newbie Help!
« Reply #20 on: June 20, 2006, 09:08:01 PM »
Download the development version of the Mach3 and it will have Lcam as well :) Just write down all the ports and pins settings and enter them into mach3. This should be a very simple setup :)
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: Newbie Help!
« Reply #21 on: June 20, 2006, 09:09:55 PM »
Brian thanks for the help really apreciate!!

Regards,

Roberto