Hello Guest it is November 09, 2024, 07:54:49 AM

Author Topic: removing mach3 driver  (Read 6502 times)

0 Members and 1 Guest are viewing this topic.

removing mach3 driver
« on: August 09, 2008, 01:49:44 PM »
I just installed mach3 for the 1st time and didn't think to ask if I needed the driver or not when using mach with the dspmc/ip plugin.  Apparantly I don't so I figure I should remove it since it's supposed to be a burden on the system.  Anybody know how to do that?  I'm contemplating just doing another clean install of xp.

Offline ger21

*
  • *
  •  6,295 6,295
    • The CNC Woodworker
Re: removing mach3 driver
« Reply #1 on: August 09, 2008, 02:26:20 PM »
Right click on My Computer, choose properties. Click the Hardware Tab, and go to device manager. Find the driver and remove it.
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html
Re: removing mach3 driver
« Reply #2 on: August 09, 2008, 02:48:14 PM »
Thanks,

That's all there is too it?  The installation tutorial video makes it sound like the mach driver installation does a lot of who knows what.

Right click on My Computer, choose properties. Click the Hardware Tab, and go to device manager. Find the driver and remove it.