Hello Guest it is March 28, 2024, 10:55:22 AM

Author Topic: Threading wizard  (Read 4192 times)

0 Members and 1 Guest are viewing this topic.

Vmax

*
Threading wizard
« on: December 10, 2005, 03:44:05 PM »
Brian did you have time to work on the threading wizard? Can I download the lastest NFW without downloading the latest version of Mach3? I like to wait before upgrading Mach versions. Terry Parker
Re: Threading wizard
« Reply #1 on: December 10, 2005, 03:57:20 PM »
Sorry, what threading wizard are you talking about?? the one in the NFS wizard ot the turn wizard?

I fixed the one in the turn wizard but not the NFS... I didn't think there was a problem in the NFS wizard. I will fix it ASAP if you tell me more.
Thank you
Brian
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

Vmax

*
Re: Threading wizard
« Reply #2 on: December 10, 2005, 08:28:54 PM »
Sorry Brian I should have explained further. We had talked about doing a rigid type tapping scheme and use a slipjoint tap holder

I can set up the Drill wizards for taping but it will not be rigid  taping... Mach3 can not rigid tap, but you can run a floating tap holder and tap.
What I will do is add in a setting for tap and have a dialog box pop up with a few questions that you will have to answer.

Thank you for the input
Brian
« Last Edit: December 10, 2005, 08:31:11 PM by Vmax »
Re: Threading wizard
« Reply #3 on: December 11, 2005, 12:24:26 AM »
I see :) I was thinking bout thread milling :-)


It is on the list and I think it is going to be soon

Brian
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com