Hello Guest it is March 28, 2024, 07:08:41 AM

Author Topic: Look Ma no dividing head  (Read 5312 times)

0 Members and 1 Guest are viewing this topic.

Offline John S

*
  •  111 111
  • Nottingham England
    • View Profile
Look Ma no dividing head
« on: July 14, 2008, 07:14:38 PM »
So I picked this lump of brass up today and thought "I wonder what's hiding inside this ?"

Threw an old Myford chuck on the bed of the trusty old KX1.1 and lobbed the brass in roughly on centre.

Bit of stabbing with a 6mm cutter got it to look like this.



Swapped to a 2mm ball nosed cutter and ran the intermediate file and sure enough this was hiding inside.




Ran the finishing file which does a cut at 90 degrees to the first and got this.



Still got a few tool marks but most will polish out with a bit of wet and dry.

Could have made it better with a less value step over of the finish tool but didn't want to waste a lot of time if it wasn't going to work.

Crap video of it doing one of the final cleanup passes here.

http://www.youtube.com/watch?v=RV8Dq6mslnE

John S.

Offline Chaoticone

*
  • *
  •  5,624 5,624
  • Precision Chaos
    • View Profile
Re: Look Ma no dividing head
« Reply #1 on: July 14, 2008, 07:41:49 PM »
Good job John. Looks great! Your an artist.   :)

Brett
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!

Offline Greolt

*
  •  956 956
    • View Profile
Re: Look Ma no dividing head
« Reply #2 on: July 15, 2008, 08:01:30 AM »
What CAM are you producing those toolpaths with John?

Pretty impressive.  :)

Greg