Hello. I bought a G100 (serial number? E8).
I connected G100 with my computer with a cross over cables.
At first, I could see the firmware upload pages on my web browser.
But after sending a latest firmware, I cannot connect to the G100.
I checked with my straight cables with switching hub, and USB cables.

Using Grex-loader, I can find G100's IP address and computer IP address.
I turned off my firewall, reset my computer, switch on and off my G100
again and again,,, but I cannot see the firmware pages.

Also, I cannot ping to G100, nor I cannot recognise G100 from MACH3 software.

G100 IP address is now 192.168.0.10. But I tried to change it to 192.168.100.1
and 192.168.200.10 etc... but in vain.   

Can anyone give me some advice?
Naomichi