Hi, D CUSTOMS
The start of Roadrunner file: Starts at lower left x0 y0, Size is x 7.7282 y 6.3797 (You can see these values on Tool-Path & Diag. Screens top right.
This G-code file doesn't require a tool setup, Best I can See.
Best cutter to use is a V engraving cutter, Jog to a x, y, position that allows enough +x,+y room on your table and Zero X, Y axises.
Jog Z to about 0.060 above top of material, Zero Z axis, this will give you a .040 cut depth.
Rapids will be z +0.200 and cut depth z -0.100 (-0.040 cut in material with cutter zeroed at 0.060 above material).
As "Sid" stated without lic. 500 lines of G-code will be executed, But it went to line 1160, Not sure what caused that to happen.
F60.000000 ; sets feed-rate to 60.0 inch per min for G01,02,03's and G00's at your velocity setting unless the FRO % is in over-ride.
G0 X0.000000 Y0.000000 Z0.200000 ; First move Z up to + 0.200
M3 ; Spindle ON
S60.000000 ; Spindle speed 60.0, If you have spindle speed feedback you will want to edit this to a faster speed.
G43H5 ; Apply tool lenth offset + to H5, Don't think you have tools set up, should have no effect
G0 X0.000000 Y0.000000 Z0.200000 ; Redundant line
G0 X1.179950 Y4.004260 Z0.200000 ; position to start for cut
G1 X1.179950 Y4.004260 Z-0.100000 ; Z down to -0.1000
G1 X1.179950 Y4.004260 Z-0.100000 ; Cut continues
Hope this Helps, Chip