Hello Guest it is March 28, 2024, 05:13:20 AM

Author Topic: skipped steps with anything better than 1/2 step  (Read 2932 times)

0 Members and 1 Guest are viewing this topic.

skipped steps with anything better than 1/2 step
« on: June 09, 2008, 11:55:29 AM »
I have built my own machine for woodworking purposes. I have 2 motors which drives my y-axis, which develops missed steps. I was using 1/8 steps, but after 120 seconds, it would start to miss steps every 10 seconds. I dropped the steps down to 1/2 steps and all is well. I suppose I can get by with this, but at slow speeds, it just doesn't sound nice and is slightly jerky, which may not be noticeable for woodworking...
I am running these motors in parallel, 640 oz-in., direct drive rack and pinion. The breakout board is a 4-axis board, which the co. that built it no longer exists (Awesome!).
My other 2 axis are flawless.
I would like to incorporate a gear reduction system for the y-axis, but it seems quite pricey.

Any ideas?