Hello Guest it is July 01, 2022, 03:22:32 AM

Author Topic: animatics motors  (Read 3166 times)

0 Members and 1 Guest are viewing this topic.

animatics motors
« on: May 03, 2008, 02:34:08 PM »
I have asked this before and got a response but I lost the email.
I am putting animatics motors on a manual mill.
Who is developing a MACH3 system to use these serial motors?
I think it was one of the moderators that responded but I cannot remember.
You may email me at jimwea@gmail.com.
Re: animatics motors
« Reply #1 on: May 03, 2008, 02:42:25 PM »
Hello Spanky, I remember your earlier post.
I have similar motors that I am still planning to use with Mach. All I have done so far is to configure them to accept step/dir signals from Mach and verify that the will work.

Here is the link to the other topic.

Re: animatics motors
« Reply #2 on: May 03, 2008, 02:50:33 PM »
Please keep me informed if you will.
these motors are great and I really want to use them.
Re: animatics motors
« Reply #3 on: May 03, 2008, 06:04:51 PM »
I won't be putting mine together for a while, I have a much larger fish to fry right now. I would say just make sure that they are sized right for your application, go through your motor software and configure them to work with Mach an GO FOR IT !
I'll keep you posted and watch for your posted progress as well.
Good Luck,