i finally got my spindle wired with a vfd and 3hp motor. i went to try it out and after some fiddling got it working. i can vary the speed and i can go forward and reverse however the spindle doesn't shut off when i program an M5, M2, or M0 command. it will slow down but the vfd still runs at 12hz. i don't understand why this isn't shutting down. i have spindle setup on port 16 for step and port 17 for direction. i'm not using output 1 and 2 i'm using the spindle setup under the motor connections. any help is much appreciated.
thanks
jerry