Hello Guest it is April 23, 2024, 10:08:32 PM

Author Topic: Problem with MDI at startup  (Read 2638 times)

0 Members and 1 Guest are viewing this topic.

Offline mwb

  •  3 3
    • View Profile
Problem with MDI at startup
« on: May 11, 2006, 12:09:10 PM »
When I first start up Mach 3 mill I have a problem with the MDI.  After homing the machine I enter an
absolute position using G90, but I get no response.  If I enter a G01 to any position it will move as
requested.  After the G01 command, the G90 will respond, however it moves at feed rate and not
rapid.  Thanks for any help.
Re: Problem with MDI at startup
« Reply #1 on: May 11, 2006, 02:24:30 PM »
Try entering G00 G90 (xpos ypos) This should make it move at rapid to the position that you would like.
Fixing problems one post at a time ;)