Hello Guest it is April 19, 2024, 03:01:47 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: How does the system wait for spindle reach full speed.  (Read 4070 times)

0 Members and 1 Guest are viewing this topic.

Offline rceebuilder

*
  • 33 33
    • View Profile
    • @pump_upp - best crypto pumps on telegram !
How does the system wait for spindle reach full speed.
« on: March 26, 2008, 09:33:31 PM »
My spindle  needs some time to reach full speed  So the axis movements should  wait for a while. How can I  do it by a macro?

Rceebuilder
Logged

vmax549

*
Re: How does the system wait for spindle reach full speed.
« Reply #1 on: March 26, 2008, 10:07:17 PM »
you could do it by macro but you moght want to try the spindle delay settings you can set spinup and down cw and ccw. Or just set a g4pXX setting after the m3 and before the next g movement.

(;-) TP
Logged

Offline Bodini

*
  • 216 216
    • View Profile
Re: How does the system wait for spindle reach full speed.
« Reply #2 on: March 27, 2008, 12:18:29 AM »
It's built in.  Mach>config>ports and pins>spindle setup (tab)>general parameters section.
Logged
Pages: 1   Go Up
« previous next »