Hi, Emtffkev
Edit: Just saw your last post, Try to use DXF ver. 12 export, your farther along than you stated I See., Chip
Just something real short.
If you don't have Mach3 Installed now, Install it The install will ask Where it should be, C:\Mach3
Draw a square in auto-cad in the Standard X-Y plane 2D, 2 x 2 inch's.
Save the File, Use, Save As, Select DXF, Name it " Test1 " save to C:\mach3\Gcode Folder, then ACAD Ver 12, If asked.
Start up Mach3, Use the Mach3Mill Icon on your desk top.
After Mach3 opens Click on RESET Button, Bottom RT, Then, Top left of mach3 screen, Cilck on Files, then Clock on LazyCam name.
LazyCam Will Open, In the top left corner of LCam Find the "Open DXF" , In File OPEN Window find Mach3 folder Dbl Click on it.
Then find the GCode folder, Then Dbl Click on it, and you should see your Test1.DXF file.
May need to change "Files of Type" to All though at the bottom of this window.
Click on the file and then Open button, You should see the Square, on the RT side of LCam, Click on "Clean" then "Optimize" Buttons.
Then The Post Code Button top RT.
Minimize LCam and Mach3 should show your Square. There won't be a correct Depth of cut because we dident set it up in LCam while we were there.
Just a Start "quick start", Hope I didn't louse you any where along the way. Getting late hear !!!
Have Fun See'ya Tomorrow, Time Permitting.
Hope this Helps, Chip