Hello Guest it is March 28, 2024, 10:29:22 AM

Author Topic: Tell me where to get ball screws in UK  (Read 4217 times)

0 Members and 1 Guest are viewing this topic.

Offline jimpinder

*
  •  1,232 1,232
  • Wakefield, West Yorks, UK
    • View Profile
Tell me where to get ball screws in UK
« on: March 03, 2008, 01:48:16 PM »
My lathe was relatively cheap, and suffers from a large amount of backlash on both axis. This was fine when I was only using it manually, but it does suffer now it is CNC.

Can anybody tell me where to get new leadscrews etc - preferably ball screws in the UK.

My lathe is a large Warco.
Not me driving the engine - I'm better looking.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Tell me where to get ball screws in UK
« Reply #1 on: March 03, 2008, 02:51:35 PM »
I know Marchant Dice sell them, what prices are like I dont know as I have never bought new ballscrews other than from eBay.
Hood

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Tell me where to get ball screws in UK
« Reply #2 on: March 03, 2008, 02:52:29 PM »
oops, forgot the link http://www.marchantdice.com/

Hood
Re: Tell me where to get ball screws in UK
« Reply #3 on: March 03, 2008, 05:11:37 PM »
Motion Controlled Products are also selling them not as big a range as Marchant Dice but the ball nuts are cheaper

http://www.motioncontrolproducts.co.uk/

After a disastrous start into the word of CNC i am also using the drivers and power supply's from them and they are awesome.

Phil_H
The Good Thing About Mach3, Is It's very Configurable

The Bad Thing About Mach3, Is It's Too Configurable

Offline jimpinder

*
  •  1,232 1,232
  • Wakefield, West Yorks, UK
    • View Profile
Re: Tell me where to get ball screws in UK
« Reply #4 on: March 04, 2008, 03:52:50 AM »
Thanks for the replies - plenty to go at there !!!
Not me driving the engine - I'm better looking.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Tell me where to get ball screws in UK
« Reply #5 on: March 04, 2008, 04:31:57 AM »
Jim
 www.arceurotrade.co.uk also has ball screws now but think they only go up to about 16mm Dia

Hood

Offline jimpinder

*
  •  1,232 1,232
  • Wakefield, West Yorks, UK
    • View Profile
Re: Tell me where to get ball screws in UK
« Reply #6 on: March 04, 2008, 06:26:57 AM »
Yes - the lead screw is 20mm, and I don't think I want to go below that - I'm trying to get a bit more speed out of it, as well as get rid of backlash.  It would do for the cross slide, however, that is thinner.

Phil H's Motion Control site looked promising. I have an engine to finish for a customer before Easter then I will have a serious look at it.
Not me driving the engine - I'm better looking.