Hello Guest it is May 19, 2025, 10:50:24 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: lazy cam turn arc  (Read 7038 times)

0 Members and 1 Guest are viewing this topic.

Offline wnevels

*
  • 65 65
lazy cam turn arc
« on: February 23, 2008, 09:49:53 PM »
Lazy cam turn has always put in G3 instead of G2.  So far I have always just done a find replace.
I'm not whether its a switch that i have set wrong or just the way it thinks.
I'm wonderiing if I was to change it to rear post would that fix it.
Mine is a front post.

any ideas.

Wes
Logged
Have a nice Day

Offline freddy

*
  • 6 6
Re: lazy cam turn arc
« Reply #1 on: February 24, 2008, 02:19:24 PM »
Under Config/Ports and Pins/Turn Options, there is an option for Reversed Arc's in front post, however you'll need to change it back if you use a wizard.
Hope that might help.
Logged

Offline wnevels

*
  • 65 65
Re: lazy cam turn arc
« Reply #2 on: February 24, 2008, 03:57:45 PM »
reversed arcs was checked.
unchecked it and now all is good.
Thanks that had been driving me nuts

Wes
Logged
Have a nice Day
Pages: 1   Go Up
« previous next »