Just ran a 3d sign from the trial v of vcarve (you have propably tested the bullshead sign yourself?)
I ran it first in exact stop mode and then in cv mode, during the exact stop mode the movements where pretty "shaky" if thats understandable.
A lot smother in cv mode.
What is the difference here, can anyone explain this to a newbie?
The result was also pretty much the same.
Cut this in solid oak, but I am not sure I am all that satisfied with the result, ill try to post apicture later.
Ran the machine on 1000 mm/min with a 60 degree v bit
Cory