Hello Guest it is March 18, 2024, 10:17:38 PM

Author Topic: Spindle output not function  (Read 2978 times)

0 Members and 1 Guest are viewing this topic.

Spindle output not function
« on: September 19, 2008, 12:27:01 PM »
I to all can´t figured why spindle relay don´t start when i press spindle button and m3 or m5 function. At ports and pins i have set output enable port 1 pin number 2 and in the Spindle Setup tab i unchecked Disable Spindle relays. At the diagnostics everything work fine. The only way that i put it to work is set the Active low on at the outputs tab , but then the only way to stop it is cut the power.Any suggestion?

  Thanks in advance

Marco

Offline Kristin D

*
  •  203 203
  • Take that you LazyCam, next stop the glue factory!
    • View Profile
Re: Spindle output not function
« Reply #1 on: September 19, 2008, 01:31:15 PM »
Marco,

Can you attach a sketch of your relay circuit & part number or relay type, it would help to answer your question.

Kristin
Re: Spindle output not function
« Reply #2 on: September 20, 2008, 09:59:41 AM »
Problem solved! It was a malfunction in the Cmos of BreakoutBoard.

Thank you any way