Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: marcolagares on September 19, 2008, 12:27:01 PM
-
I to all can´t figured why spindle relay don´t start when i press spindle button and m3 or m5 function. At ports and pins i have set output enable port 1 pin number 2 and in the Spindle Setup tab i unchecked Disable Spindle relays. At the diagnostics everything work fine. The only way that i put it to work is set the Active low on at the outputs tab , but then the only way to stop it is cut the power.Any suggestion?
Thanks in advance
Marco
-
Marco,
Can you attach a sketch of your relay circuit & part number or relay type, it would help to answer your question.
Kristin
-
Problem solved! It was a malfunction in the Cmos of BreakoutBoard.
Thank you any way