Hello Guest it is March 29, 2024, 03:19:52 AM

Author Topic: Odd behaviour while probing  (Read 2444 times)

0 Members and 1 Guest are viewing this topic.

Odd behaviour while probing
« on: January 16, 2008, 02:36:25 PM »
I have scored some renishaw probes of Ebay, and now have a digitizing
probe and a tool setting probe.

I was running the tool sensing probe and all was working well, then
switched to the digitizing probe to set Z=0 and when i started the z
probe routine the mill started moving Z up in stead of down. I stopped
the routine and tried again with the same results. I Reset Mach3
(software reset) and behavior normalized.

Can anyone explain this behaviour? I can't see how switching from one
probe to the other could affect this, It must be software
related,perhaps in the switch from toolsetter Z probing to digitizer
probe Z probing? It's especially odd given that both probe procedures
require a Z neg move.

Thanks for the attention,
Wayne