Hello Guest it is May 05, 2025, 04:33:53 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: AIO-400 Board  (Read 8656 times)

0 Members and 2 Guests are viewing this topic.

Offline dosuser

*
  • 1 1
AIO-400 Board
« on: January 11, 2008, 08:19:13 PM »
Has anyone used this board with Mach3 software?
Could you give me setup information?
Unipolar Steppers.
I,m a newbie.
Logged

Offline Graham Waterworth

*
  • *
  • 2,781 2,781
  • Yorkshire Dales, England
Re: AIO-400 Board
« Reply #1 on: January 13, 2008, 06:34:10 AM »
Mach should drive that board, problem is, it is very low power, 300mA is not much to drive a machine, a printer carriage maybe. Most machines need 2.0 to 3.0A minimum.

Graham.


Logged
Without engineers the world stops
Pages: 1   Go Up
« previous next »