Hi All,
So found out a few more things. I changed my home switches to normally closed and I tried bring on-line one axis at a time.
The Z-axis seems to home OK. When homing, it will move towards home, trigger the home switch, and them move off. The DRO will read 0.000 after it does this.
The Y-axis does not seem right. When homing, it will move towards home, trigger the home switch, and them move off. The DRO will read something like -3.1025 and not 0.000 like the z-axis. It does seem to home though.
The X-axis is still a problem. I had to replace the home switch because the machine crushed the one I was using. When homing, it will move towards the home switch, it will trigger the home switch but not back off. It will keep on going, that is how the home switch got crushed and destroyed. The other thing I noticed of the x-axis is that when using the jog control, it does not matter if I jog in the + or the - direction, it will always moves towards the home switch. It will not move away.
The other axis seem to move in the correct direction when jogging. I am at my wits ends on this, cannot figure out what is wrong.
Thanks,
rene