Hi TonyP,
Sorry for the delay, I was working late.
Attached NC file is as posted, I tried the Tnn00 (T0200) like Graham suggested, but still no luck.
If you can test the NC file it would eliminate one factor.
I think I may have a problem in the way I am setting up the tools
I am used to using G53 for home (machine coords) and G54 for work coords
I am not sure when I setup where I am, no display of current coord.
perhaps a brief description how you setup would help. I pretty much followed the manual but may have deviated due to lack of info/understanding
Thank you
Friedrich