Author Topic: Griffin PowerMate  (Read 2160 times)

0 Members and 1 Guest are viewing this topic.

Offline tbriggs

  • Active Member
  • Posts: 17
    • View Profile
Griffin PowerMate
« on: December 30, 2007, 09:24:12 PM »
I just purchased one of the Griffin PowerMates.  I downloaded the plugin.  Since I am kind of new to this I have a couple of questions.  Do I need to install the PowerMate software and configure anything for Mach3?

When I press the top of the device it toggles between the available axis but nothing happens when I turn the knob.

Am I missing something?

Thanks!

 ???

Offline Hood

  • Mach4 Alpha
  • Posts: 25,775
  • Carnoustie, Scotland
    • View Profile
Re: Griffin PowerMate
« Reply #1 on: December 31, 2007, 03:19:38 AM »
Dont have one so have never looked at the plugin but maybe you have to go into the plugin and set it up? You may find a config page for it from the operator menu.
Hood