I am having problems with my system since I installed a new motherboard. I can't seem to get mach to run my stepper motors. Now before I go into to long of a question, is there any simple way to test the parallel cable to see if it is working? I don't have a printer or anything else to check it with, but may by I can read voltage on a pin? I changed to an Asus M2N32-SLI motherboard and installed the cable for a parallel cable as the instruction said, using same cable that I used before for my Xylotex system and Mach 3 which all worked fine with last motherboard, so thinking it might have something to do with the port.
Just want to start with checking the port to see if it is working.
Any help would be appreciated, thanks
Jim