Hi, the problem was that the machine was using a very old version of Mach3. I'm going to install a new version of Mach3 so I can use it.

The current version of the machine has an ATC, so the operator can manually select the tool number they want to use. How can I configure this?

Another problem I have when using the new version of Mach3 is that the axes move very slowly, at low speeds. How can I increase the speed?

Hello my friend.

I'm still having problems regarding the minimum Y...

I'm attaching two photos. The minimum Y in G code is Y100. Look at the value Mach3 displays.

hello,
can you pls. post your GCode so i can test here?

Thank You

Hola, claro publico aqui el codigo G

He descubierto que una macro, es la que me altera los valores, ''fixture.dat'', pero aun asi me sigue marcando el valor MinY como 0

if i test your posted GCode here, everything looks fine.

There is a macro that generates this malfunction in mach3

Hello friend and happy New year.

I have a problem in other machine.

I have installed a csmio ip-s and I have a problem with Mach 3, when resetting Mach 3 to remove the emergency, it activates the activation output of the spindle, can you help me?

only thing i can imagine that in

Config -> Ports&Pins -> Output Signal's one of the enable output's is
assigned to the spindle enable Output.

otherwise post your Config file here.

Yes, that is the assigned output, but mach3 activates the spindle without running g code.

the enable output's in

Config -> Ports&Pins -> Output Signal's will allways be enabled after reset E-Stop

spindle outputs are assigned in

Config -> Ports&Pins -> Spindle setup
one Mach3 outputnumber for CW (M3)
and an other Mach3 outputnumber for CCW (M4)

and then in
Config -> Ports&Pins -> Output Signal's
you have to assign the "real" output from your CSMIO/S