I have purchased a Chinese stone cutting gantry router and it has problems that are frustrating me. It is like Groundhog Day every time I restart the machine. It reverts to all it's old settings - including removing any G-code files that I load. It has developed a fault, that I previously managed to remedy but it has come back.
The operating system is W7 Embedded and the motion control software is in Chinese and Delta haven't replied to my enquiries about getting an English version.
I am now wanting to try running Mach3 as I am familiar with it.
The machine has all Delta hardware and the servo drives are ASDA B3  controlled by DMCnet, which is Ethernet, I think, and RS485 for the rest of the control.
Can I use Mach3 or 4 with this setup.
Any help woul be much appreciated.   Ross