Hello Guest it is May 24, 2025, 11:46:59 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: mach3 Lpt spindle setting  (Read 5564 times)

0 Members and 1 Guest are viewing this topic.

Offline erdem55

*
  • 13 13
mach3 Lpt spindle setting
« on: March 20, 2023, 07:54:16 AM »
Hi guys,
I change from rnr to uc100, and
I need  mach3 lpt spindle setting knowledge.I has a problem that pwm output on off  is 9.7v .I press spindle on ,motor  turned full rpm.
Logged

Offline JohnHaine

*
  • 943 943
Re: mach3 Lpt spindle setting
« Reply #1 on: March 20, 2023, 05:02:42 PM »
Is the UC100 connected to a breakout board?  As far as I know (I have 2 of them) its outputs are all 5V, where are you measuring 9.7v and what is your circuit?
Logged
Pages: 1   Go Up
« previous next »