Hello,

I hope this is the right section for this question, if not i'm sorry.

I just have a few questions regarding the offline control of a 6040 cnc unit but using the
ddcsV3.1 control unit....
I'v wired up the unit but unfortunately cannot get the spindle to start.
Does the AVI from the VFD board go to the VCO terminal on the breakout board of the DDCS?
There is a yellow 10V wire coming from the VFD. Where should this go?

Many thanks
R.

Unfortunately, the DDCSv3.1 is Digital Dream aka Novusun product and is not supported by this forum. This thread relates:  https://www.machsupport.com/forum/index.php?topic=24331.msg171954#msg171954

Tweakie.