Hello Guest it is September 28, 2021, 12:38:47 AM

Author Topic: closed loop  (Read 2420 times)

0 Members and 1 Guest are viewing this topic.

closed loop
« on: November 04, 2007, 11:40:51 AM »
how do i set up a closed loop system in mach3 ?i went to used encoders with my steeper to make sure that i do not loose steps.

Offline Hood

  •  25,838 25,838
  • Carnoustie, Scotland
    • View Profile
Re: closed loop
« Reply #1 on: November 04, 2007, 02:02:01 PM »
You will need one of the Encoder Interface boards that Ron Rogers sells www.rogersmachine.net It will not be true closed loop but Mach will halt if there is an error greater than the following error that you set.