Hello Guest it is June 10, 2023, 06:57:47 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Motor Tuning and Setup  (Read 189 times)

0 Members and 1 Guest are viewing this topic.

Offline enzed

*
  • 7 7
    • View Profile
Motor Tuning and Setup
« on: February 05, 2023, 09:51:40 AM »
I will appreciate it if someone can explain to me what is the function of "Step Pulse 1-5 us" and "Dir Pulse 0-5" in the Motor Tuning and Setup page, and what must these parameters be set to. I use Mach3 for plasma cutting. Thanks
Logged

Offline Graham Waterworth

*
  • *
  • 2,579 2,579
  • Yorkshire Dales, England
    • View Profile
Re: Motor Tuning and Setup
« Reply #1 on: February 11, 2023, 08:33:23 PM »
It is the pulse to pulse delay, most modern stepper drives are fine with this set to 1 older drives may need more, the higher the number the slower the axis can run.
Logged
Without engineers the world stops

Offline enzed

*
  • 7 7
    • View Profile
Re: Motor Tuning and Setup
« Reply #2 on: February 11, 2023, 11:56:08 PM »
Thank you for the explanation.
Logged
Pages: 1   Go Up
« previous next »