After 12 really simple years of using Windows XP my computer finally took a dump.  Went to a different computer using Windows 10 and spent 3 days reprogramming pretty much everything.  A couple of issues that I could use some help with.  #1 when I open Mach3 I have a variety of 10 Different error codes to check off before I can open Mach 3?  #2 I use vcarve pro and when I load any g code I have to advance to N170 before anything will allow my programing to start. 

Motion controller? I use M3 with a UC100 USB controller with Win10 andnthe upgrade from XP with PPT was seamless.