Hello Guest it is April 25, 2024, 04:18:04 PM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Mirroring tool path in tangential mode Mach4  (Read 1011 times)

0 Members and 1 Guest are viewing this topic.

Offline adiniz

*
  • 15 15
    • View Profile
Re: Mirroring tool path in tangential mode Mach4
« Reply #10 on: August 24, 2022, 12:50:53 PM »
Good afternoon Bill_O!
Yes!
everything would be simple if i could set up the table R2L (right to left flow). But the entire cut line is L2R, and the bridge (Y axis) is hommed at right!
There is a way to mirror only the tool path?
Thanks a lot!
Logged

Offline Bill_O

*
  • 563 563
    • View Profile
Re: Mirroring tool path in tangential mode Mach4
« Reply #11 on: August 24, 2022, 01:29:17 PM »
I know how to rotate it but not mirror it.
In your toolpath software change the 0,0 point to match your machine.
Logged
Pages: « 1 2   Go Up
« previous next »