Hello Guest it is May 07, 2025, 11:21:08 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: program goes to top line in mach4 while running a program  (Read 2807 times)

0 Members and 2 Guests are viewing this topic.

Offline mikealex1970

*
  • 5 5
program goes to top line in mach4 while running a program
« on: January 26, 2022, 01:53:36 PM »
I am running mach4 with plasma and during a program run it will randomly send to top of program for no reason
Logged

Offline SwiftyJ

*
  • 230 230
Re: program goes to top line in mach4 while running a program
« Reply #1 on: January 26, 2022, 01:57:23 PM »
I have noticed something similar. Does it jump up to around line 3 and then back down to where it was? For me it does it after probing/initial height sense
Logged

Offline mikealex1970

*
  • 5 5
Re: program goes to top line in mach4 while running a program
« Reply #2 on: January 26, 2022, 08:31:35 PM »
it goes to line 2 and leaves the torch on and no movement
Logged
Pages: 1   Go Up
« previous next »