Hello Guest it is May 19, 2024, 11:07:50 AM

Author Topic: On/Off for hand motor router  (Read 3884 times)

0 Members and 1 Guest are viewing this topic.

On/Off for hand motor router
« on: December 30, 2021, 06:26:37 PM »
Hello, can anyone help me?
I have installed Mach4 and I already have my motors and limits , but I cannot get a signal to turn on and off the handheld router that I have installed. I can't get the output signals from my XHC card to work. (Modbus is not present in the plugins, could that be?)
Greetings.
Re: On/Off for hand motor router
« Reply #1 on: December 31, 2021, 10:14:54 AM »
Have you enabled your spindle on in the plug in tab and mapped it on your outputs config?
Todd