Hey fellow engineers,

So I build my first CNC and besides some minor issues everything worked great so far.
The only thing left to do is to get the Spindle running via the Mach3 software, it already took me 2 weeks of troubleshooting and a lot brain cells I probably wont get back.
I connected it like this guy right here with a PWM module https://www.youtube.com/watch?v=W1B9VC-6WL0 - didn't work.
In the meantime i connected it in every way i could find online but i dont remeber them,
Right now i connected it like this https://buildyourcnc.com/FAQ/14137 - still doesnt work.

P00.01 is set to 1 (Start / stop command source - From external end control Electric machinery,operation panel STOP key effective)
P07.08 is set to 3 (Frequency source selection 1 - Motor speed control by external terminal)
Mach 3 USB Controller : (https://www.buildyourcnc.com/item/electronicsAndMotors-electronic-component-breakout-Mach3-USB-Board)
VFD : YL620 2,2kw
I also attached my Mach 3 Settings and a picture of my baby.




I am at my end, and I hope some angel helps me get this bad boy running like he should be.

Anybody ?