Hello Guest it is March 28, 2024, 12:56:31 PM

Author Topic: problem with variable speed mach 3  (Read 801 times)

0 Members and 1 Guest are viewing this topic.

problem with variable speed mach 3
« on: October 25, 2021, 05:13:50 AM »
Hello Chaps.
I am having a problem with mach 3- the s word.
I am using a VSD and would like help in trouble shooting.
the problem is that the speed does not respond to mouse clicks for accelerate of decelerate.
I have checked the VSD and it is OK. ( agent checked for me )
It has worked correctly before but the VSD has been disconnected and I dont trust the person who reconnected it - he might have connected to the incorrect points on the breakout board.
Please tell me which terminals it must be connected to and if there are any special settings that mach must be initialized with.
any suggeations will be very much appreciated.
regards

fred evans
think of the trees-- use both sides of the computer paper
Re: problem with variable speed mach 3
« Reply #1 on: November 02, 2021, 04:19:20 AM »
hello There- anyone know where I can get help in setting up my VSD??
regards

fred
think of the trees-- use both sides of the computer paper
Re: problem with variable speed mach 3
« Reply #2 on: November 05, 2021, 05:53:15 PM »
To help people would need to know model of VSD, breakout board and probably the spindle also.
Re: problem with variable speed mach 3
« Reply #3 on: November 06, 2021, 01:15:12 PM »
thank you
regards

fred
think of the trees-- use both sides of the computer paper