Hi all! I am new to this board and hoping I can get a little help. I'm sure this has been brought up before, but my issue is this.
I have a shop saber 48x96 that was purchased in 2006.  recently I ran my Y axis servo a little to hard and had to replace it. 
My drive is an older MR-E-40A-QZ.  When hooking up the new servo, I get an overload error right away.
I downloaded the MR 2 Configurator so I can have a look, but the drive is not on the list.
So, my question is, is there an older MR 2 config to download? or is there another software out there that is compatible with that drive?

Hoping someone out there had a similar issue.

Thanks, Brian